Assembly distributor IVAR.CI 557 KS, 3-way

Code: 557671KS

naparovana cena na magic

Brand: IVAR

25223 dual zostava pre kombinaciu vykurovania bez skrine 3 4 xek 3cestny mosadz

25223 1 dual zostava pre kombinaciu vykurovania bez skrine 3 4 xek 3cestny mosadz

–20 % €550,11 / pcs

In stock

Detailed information

Show all related products

Product detailed description

Divider assembly IVAR.CI 557 KS, dimension: 3/4" x EK, 3-way

- DUAL - assembly for combination of underfloor heating with radiator heating

PN 6, T = +90 °C
connection thread internal 3/4" F
material brass CW617N

Assembly includes:

distributor with control flow meters
collector with shut-off valves
fixing brackets
thermostatic valve with thermostatic head and separate immersion temperature sensor for constant temperature control
regulating fitting
circulating pump with wiring
insurance thermostat
2 pcs of automatic vent valves
thermometer
2 pcs of rotary drain valves

Recommended for a temperature gradient of the radiator part of the system +75 ?C / +65 ?C

Seated circulation pump: DAB.EVOSTA 2 40-70/130

Circulation pump shutdown is not part of the manifold, it can be solved by a higher-level control or by a control thermostat for circulation pumps IVAR.AC 614 E.

Pump frontal rotation to position A = 165, construction depth = 160 mm

Pump rotation lateral to position A = 220, construction depth= 132 mm

Note:

The thermostatic valve at the inlet to the assembly can alternatively be replaced by a thermostatic valve with Vats flow, Kv, type VDS 01, 02.

Attention:

the flow meter is integrated into the inlet water control fitting
the unit is NOT intended for use in combination with a condensing boiler or heat pump
the seller is not responsible for functional defects caused by impurities in the system

Notice:

Before any commissioning of the , especially when combining underfloor and radiator heating, it is strongly recommended to flush the entire system according to the manufacturer's instructions. We recommend treating the system with GEL.LONG LIFE 100.

The manifolds are stored in cabinets, their recommended lengths are given in the manifold table. Fitting dividers in the highest point is virtually a requirement (beware of level changes in floor plans). The exception to this is the venting of small floor dividers on the upper floor via the bathroom ladder. If the floor system is made only in the bathrooms, it is possible to use piping from the return branch of the radiator system with a protector or to use a direct acting temperature controller at the end of this parallel loop to ensure cooling to a low temperature level (caution! it must be thermally separated from the return line of the radiator circuit so that it is not thermally affected).

For further information, you can go to https://www.systemova-doska.sk/podlahove-vykurovanie/