Assembly distributor IVAR.CS 553 DRS, 3-way

To facilitate the adjustment of the underfloor heating control parameters, we recommend fitting the assembly with thermometers and flow meters.

Note: The seller is not responsible for functional defects caused by impurities in the system.

Before any commissioning of the heating system, especially for the combination of underfloor and radiator heating, it is strongly recommended to flush the entire system according to the manufacturer's instructions. We recommend treating the system with GEL.LONG LIFE 100.

The manifolds are stored in cabinets, their recommended lengths are given in the manifold table. Fitting the dividers in the highest point is practically a requirement (beware of level changes in floor plans). The exception is the venting of small floor dividers on the upper floor via the bathroom ladder. If the floor system is made only in the bathrooms, it is possible to use piping from the return branch of the radiator system with a polyethylene protector or to use a direct acting temperature controller at the end of this parallel loop to ensure cooling to a low temperature level (caution! it must be thermally separated from the return line of the radiator circuit so that it is not thermally affected).

For further information, you can go to https://www.systemova-doska.sk/podlahove-vykurovanie/