Assembly manifold for heating elements - without cabinet, 1" x EC, 6-way

The manifolds are stored in cabinets, their recommended lengths are given in the manifold table. Fitting the dividers in the highest point is virtually a requirement (beware of level changes in floor plans). The exception is the venting of small floor dividers on the upper floor via the bathroom ladder. If the floor system is made only in the bathrooms, it is possible to use piping from the return branch of the radiator system with a polyethylene protector or a direct acting temperature controller is used at the end of this parallel loop to ensure cooling to a low temperature level (beware! It must be thermally isolated from the return line of the radiator loop so that it is not thermally affected).