Fittings - for ALPEX multilayer pipe, 14 x 2 ALU - EK
Code: 500683Related products
- PN 10, T = +120 °C
- thread Eurocone (EC) or M 24
- material brass CW617N, O-ring - EPDM
- tightening torque 25 - 35 Nm
- suitable for ALPEX pipe
Follow these instructions to properly fit the clamp fitting:
1. Install the clamp fitting in the sequence and snow as indicated in the following figures.
2. Insert the pipe and the appropriate EPDM gasket into the fitting and ensure that everything is clean and that there is no damage to the O-ring.
3. Fit the nut onto the thread and hand tighten, use the appropriate size AC 670 / AC 671 spanner to fully tighten
The rubber parts must not be lubricated with mineral oils under any circumstances, only silicone based lubricant should be used on the EPDM material.
No lubricant should be used on the EPDM material.
Additional parameters
| Category: | clamping screwing to alpex multi-layer pipe |
|---|---|
| Warranty: | 2 roky |
| Weight: | 0.06 kg |
| Posledná aktuálizacia ceny: | 20.11.2024 9:42:12 |
Be the first who will post an article to this item!
Add a comment