Wholesale e-shop

GRINDER FX 15.07 T-NA Submersible Sump Pump with Cutter - Action DAB.GRINDER FX

Code: 60191221
naparovana cena na magic
Brand: IVAR
–10 % €1 050,30 / ks
1 week

Detailed information

Product detailed description

GRINDER FX 15.07 T-NA Submersible Sump Pump with Cutter *AD*

The submersible slurry pumps with cutter are designed for pumping sewage from drains, in both civil and commercial environments. The pumps are certified according to the wastewater standard EN 12050-1. The pumps are suitable for fixed installations with a lifting device or portable, as long as it is placed on a base directly on the bottom of the tank. Thanks to the efficient cutting system, the pumps are suitable for installation with small diameter pipes. The pumps are designed for quick maintenance thanks to a design that provides easy access to the main pump components. Automatic versions are available with outputs up to 1.5 kW. The ATEX version is available for use in hazardous environments. (ATEX certification: II2G Ex db k IIB T4 or IEC EX: Ex db IIB T4 Gb). Pump body and impeller in cast iron, cutting system in AISI 630 stainless steel. Motor shaft in AISI 304 stainless steel. Double mechanical seal - SiC-SiC/SiC-C in the oil chamber, not in contact with the pumped liquid, independent of the direction of rotation. Discharge connection is available with both flanged and threaded connections. Single-phase asynchronous motor (M-A/M-NA version) and three-phase motor (T-NA version). The rotor is housed in lubricated ball bearings. Continuous operation is enabled in S1 with the motor fully submerged. Dry running, for a maximum of 10 minutes. Motor winding overheating sensors with intervention threshold at +130 °C. Quick-connect cable gland, sealed in resin, 07RN8-F power cable. Single phase version with starter and capacitor in separate panel, M-A version with float for automatic operation. For three-phase motors, the user is responsible for connecting the overheat sensor.

  • Operating range: flow rate up to 23.8 m³/h with discharge up to 33 m
  • Maximum immersion depth: 20 m
  • Pumped liquid: wastewater with fibre, paper or textile material, in domestic or commercial environments
  • Liquid temperature range: up to +50 °C (+60 °C for short time, +40 °C for ATEX version)
  • Flange and threaded connection: 1 1/2", DN 32, DN 40
  • Imeller type: cutting system
  • Maximum number of starts per hour: 20/h
  • Class of protection: IP68
  • Motor insulation class: F
  • Single phase voltage: 1x220-240V 50 Hz
  • Three-phase voltage: 3x400V 50 Hz / 3x 230V 50 Hz on request
  • Maximum dry running time: 10 min
  • Power cord and plug: 10 m
  • Installation: portable or fixed, with lifting device
  • Certification: EN 12050/ ATEX
  • Special version on request: different cable lengths, different voltages and frequencies

In case of need, refer to the replacement table, on page 211, for the corresponding old models.

Additional parameters

Category: DAB.GRINDER FX - sludge pump with cutter
Posledná aktuálizacia ceny: 25.11.2024 21:03:37

Be the first who will post an article to this item!

Do not fill out this field:
Vytvořil Shoptet | Design Shoptetak.cz.