Pressure vessel AQUA OLA 80l, standing

Product detailed description

Pressure vessel AQUA OLA 80l, vertical - upright serves as a storage tank for pumped water for domestic waterworks, pumping and pressure stations or industrial stations. The AQUA OLA pressure vessel is designed for customers who do not accept compromises and half-way solutions in usability. The quality in the manufacturing design of the entire product, the AQUA OLA steel pressure vessel is highlighted by the extended warranty of 3 years. Features of the AQUA OLA 80l vertical pressure vessel: The pressure vessel can be assigned to all types of pumps that do not exceed the maximum working pressure of the pressure vessel (6 bar). The pressure vessel contains a rubber-rubber (EPDM) bag designed for drinking water. The factory filling pressure is 2 bar. Generally speaking, the larger the pressure vessel installed, the fewer the pump start-up cycles and the longer the lifetime of the system. For pressure vessels with a rubber bag, it is recommended to check the air in the pressure vessel approximately once every 6 months. If a pressure vessel with a rubber bag is installed, the problem of dealing with the necessary suction of air into the vessel and the associated higher maintenance of the equipment is eliminated. Most asked question: What exactly does Pressure (bar) mean - PS pressure and MAX pressure. This is a relative expression of pressure, usually, as the pressure in some enclosed space (in our case a pressure vessel) versus the pressure in the surrounding space (often atmospheric). PS is the working pressure and indicates or denotes what is the highest possible working pressure with which the pressure vessel can operate properly and in the long term and is measured in bar. (bar) For example, in a domestic system, the pressure in the system should not exceed more than 4 to 4.5 bar and even these values are already limiting. The most common pressure in a pressurised system in houses is up to 3.8 bar. Higher set pressure values in the house can cause problems in the long run, especially the various valves and also the faucets suffer. MAX pressure is marked on the pressure vessel what pressure the pressure vessel is tested at from the factory. The overall integrity and strength and the strength of the welds of the pressure vessel are tested. The test is carried out without the bag inserted. WARNING! The pressure vessel cannot therefore be pressurised to 15bar - it will not work. The bag would stretch until it would completely encase the inside of the pressure vessel and would burst after a few repetitions.